DKU 5 SERIAL CABLE DRIVER

I keep meaning to try this but never have. The Nokia cable uses 3. Author Write something about yourself. The final output will be something like this: I explain how to do this in the article. The shell can also be put back together with little effort. The part of the “pin-out” which we care about are:.

Uploader: Faera
Date Added: 25 September 2009
File Size: 11.5 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 97021
Price: Free* [*Free Regsitration Required]

Nov 07, Want to watch this again later. I said the phone connector not the USB connector. By Servet — March rku, The dable around the USB connector is not a solid piece but a two part seroal.

First I tried using the USB-to-Serial solution but have no luck, I cannot pass the loopback test, maybe something is not right with my settings. Just as I was considering cutting up a USB phone cable, I realised that I had a full-blown Linux system with a handily accessible serial port that runs at […]. If you release the button too soon the bootloader will timeout before the program gets a chance to be uploaded and you will get an error.

Powered by Create your own unique website with customizable templates. People usually did it with a 3rd party chip.

I hope you will not tell me my situation is desperate Make sure none of the wires are touching one another! Please note that the section showing the bottom of the board was vertically flipped in GIMP to give a sort of X-ray vision effect.

  CANON IP1200 LINUX DRIVER DOWNLOAD

Now you can access Top Debug Menu: Carrington Theme by Crowd Favorite. The device when attached to window7 it gets COM5 and recognized by windows…you can see the pictures in the following thread.

A dku-5 cable made in China The cable has a label on the USB. Tem algumas coisas interessantes. Switched on everything again, then make the HyperTerminal connection.

Getting the timing right can be tricky because the bootloader only listens serail a brief period of time. To find out more, including how to control cookies, see here: However, this has caused some confusion, as most instructions showing how to build the 3. There are slightly cheaper alternatives, but a real scrooge googles on.

Ex-Link Cable for C/D/E Series and BD players – SamyGO

Studying a picture on your computer beats the hell out of using the magnifer on a Helping Hands. Hi, Manta, Just to get things straight, is there any big difference between “inbuilt firmware” your wording and “built-in hardware” my layman wording? No need to be fancy, just an overview.

Here is the finished FTDI cable: This is a common, but old, Nokia phone data cable, that cost less than 3 EUR. In reply to manta’s post on March 24, Most of the cable should remain attached to the USB connector, but you need to leave enough cable attached to the phone connector to be able to strip the wires and attach an alligator clip or a terminal block if you like.

  BENQ G2400 DRIVER

They might help someone else out.

So how does it work when the ATmega expects 5V? When attempting to program, the DTR pin cab,e go low, but it stays low, keeping the Arduino in reset instead of actually resetting the Arduino.

Nokia pop-port LIKE-DKU-5 or CA-42 cable schematic pinout

Yes, they are much more expensive, but you get what you pay for. Plug in the cable, power on the device, and start the Arduino IDE. You can find the cable in ebay, dealextreme or local stores.

After several installation attempts, I just found out, via the “Performance and Maintenance” tab Hardware section that my cable was listed, not among the Usb devices but as a du connected to a port COM 4!!!

Related Posts